Semaphore or left side not working · International Vintage Volkswagen Forums

Welcome Guest! To enable all features please Login or Register

sarah dell
Regular Topic Starter

17 years ago

Hi, up until today both Semaphores were working now pasender one isn't even attempting to lift, I'm not very good with electrics but from what I can see noting is shorted out and the drivers side is working perfectly?

Any ideas?

Thanks

Wanna join the discussion?! Login to your International Vintage Volkswagen Forums forum account or Register a new forum account

Sponsor

Log-in to remove these ads

54 Gertie
pre67vw Junkie

17 years ago

I suppose the simplest thing it could be would be a wire slipped out but it is a bit hard to diagnose without being there! :?

Really helpful I know! :lol:

Try signaling to that side, get out and try to open it with your fingers (dont jam a screwdriver in there)

It may just be being a bit stubborn and a bit of persuasion may get it moving! :wink: This is however not a solution but it may help with further diagnosis!

William

sarah dell
Regular Topic Starter

17 years ago

Tried that but doesn't want to budge and didn't want to force it, Could it be just a bulb? or does that just stop it lighting up?

Rich Oakley
pre67vw Junkie

17 years ago

Do you have a voltmeter?

47 Beetle, 56 UK Karmann Cabriolet, 56 UK Beetle, 57 UK Type 2, 59 UK Beetle, 66 UK Fastback.

sarah dell
Regular Topic Starter

17 years ago

No but prob gonna need one so can get one?

54 Gertie
pre67vw Junkie

17 years ago

The bulb will not effect is movement

It is worth checking the voltage at the battery and comparing that to the voltage at the semaphore but if the other side works perfectly it is probably down to the semaphore itself!

Edited by user 17 years ago | Reason: Not specified

William

sarah dell
Regular Topic Starter

17 years ago

54 Gertie wrote:

Does that mean I need a new one?

54 Gertie
pre67vw Junkie

17 years ago

54 Gertie wrote:

Sorry, that wasnt very clear!

If the voltage at the semaphore is considerably less than at the battery terminals that would suggest that there is a bad connection between the semaphore switch and semaphore!

Hope thats clearer! :wink:

William

54 Gertie
pre67vw Junkie

17 years ago

Does that mean I need a new one?

sarah dell wrote:

Read my previous post! I have refined what i previous said! :lol:

William

Rich Oakley
pre67vw Junkie

17 years ago

#10

Hand-held Voltmeters can be bought for a few quid. A very wortwhile investment if you're running a 6V VW! This type of thing will do the job...
https://cgi.ebay.co.uk/DIGITAL-MULTIMETER-AMPS-AC-DC-OHM-V-A-VOLTMETER-b_W0QQitemZ320357666890QQcmdZViewItemQQptZUK_BOI_Electrical_Test_Measurement_Equipment_ET?hash=item320357666890&_trksid=p3286.c0.m14&_trkparms=66%3A2%7C65%3A1%7C39%3A1%7C240%3A1318

47 Beetle, 56 UK Karmann Cabriolet, 56 UK Beetle, 57 UK Type 2, 59 UK Beetle, 66 UK Fastback.

sarah dell
Regular Topic Starter

17 years ago

#11

Gonna be really dumb here but how do I do that?

54 Gertie
pre67vw Junkie

17 years ago

#12

Gonna be really dumb here but how do I do that?

sarah dell wrote:

What? Buy something from ebay or check the voltage? :lol:

William

sarah dell
Regular Topic Starter

17 years ago

#13

Very funny ...:lol:
check the voltage,I am female after all. :d
(not got anyone techical to ask)

Dunno what i would do without the guys on this forum

Edited by user 17 years ago | Reason: Not specified

54 Gertie
pre67vw Junkie

17 years ago

#14

1) Apply + lead to + terminal on battery and do the same with the -

2) Note the reading (eg 5.57 volts)

3) Switch on the semaphore and apply the + terminal to the bottom screw connector on the semaphore (when its up) and connect the - terminal to a place on the body to get a good earth! This could go on the metal body of the semaphore.

4) Note down this reading and if it is quite a bit less than the previous reading then try to find where it is losing the voltage!

Hope this helps or has it just made you more confused? :lol:

EDIT:

+ = Positive

- = Negative

:wink:

Edited by user 17 years ago | Reason: Not specified

William

sarah dell
Regular Topic Starter

17 years ago

#15

No thats brill will try tomorrow. I am assuming I have to switch semaphore on on the stalk and manually try and lift up with fingers to do this, if stiff and have to force to lift will I wreck the semaphore?

ps thanks really appreciate you taking the time to explain to a plank like me. :d

Edited by user 17 years ago | Reason: Not specified

54 Gertie
pre67vw Junkie

17 years ago

#16

sarah dell wrote:

It is not ideal to "force" a semaphore but it will work!

I would however try to stop it from latching back in by tying some string around it. This will stop you having to force it more than once! :wink:

William

tman
pre67vw Junkie

17 years ago

#17

You have a working semaphore on the other side of the car. Why don't you swap them both over to see if the fault moves too? If it does then you have a faulty semaphore, but my money is on the switch!

Andrew
195x Deluxe oval Beetle
Binz Doublecab

International Vintage Volkswagen Forums

Important Information: